AEDG comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-06-23. Where a claim depends on a specific study, the study is described rather than over-claimed.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by HPLC area | Higher grades are also offered |
| Primary analytical method | Reversed-phase HPLC, UV detection | Frequently paired with mass spectrometry |
| Confirmatory technique | Electrospray mass spectrometry | Observed mass compared with theory |
| Storage temperature | Minus 20 degrees Celsius, dry powder | Sealed, desiccated, protected from light |
| Solution handling | Prepare fresh before use | Hydrolysis proceeds in aqueous media |
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Proposed mechanisms centre on cell-culture observations rather than a defined receptor interaction. Several reports describe increased expression of the telomerase catalytic subunit after exposure of cultured human cells, and the authors attributed the effect to short peptide fragments entering the nucleus and influencing gene transcription. No receptor for the tetrapeptide has been identified, and the free peptide is expected to be degraded rapidly by plasma peptidases. Whether any measurable fraction reaches intact tissues after administration remains an unresolved question rather than an established finding.
The published literature is dominated by a small number of research groups, much of it in Russian-language journals, and independent replication outside those groups is limited. Studies are typically small, use cultured cells or rodent models, and report endpoints that differ between papers, which makes comparison difficult. Large randomised human trials have not appeared in the indexed literature. Questions about absorption, distribution and clearance are therefore still treated as open in reviews that mention the compound.
Epitalon is a synthetic tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. Its design traces to epithalamin, a peptide fraction prepared from bovine pineal gland extracts that researchers in Saint Petersburg began investigating in the 1970s. The compound has a molecular formula of C14H22N4O9 and a nominal molecular mass near 390 daltons. It holds no approved drug status in the United States or the European Union, and material sold under this name is generally offered as a research chemical rather than a finished pharmaceutical product.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
=== Other applications === In addition to common uses previously mentioned, FRET is also effective in the study of biochemical reaction kinetics. FRET is increasingly used for monitoring pH dependent assembly and disassembly and is valuable in the analysis of nucleic acids encapsulation. This technique can be used to determine factors affecting various types of nanoparticle formation as well as the mechanisms and effects of nanomedicines.
238U(22Ne,xn)260−xNo (x=4,5,6) This reaction was first studied in 1964 at FLNR. The team were able to detect decays from 252Fm and 250Fm. The 252Fm activity was associated with an ~8 s half-life and assigned to 256102 from the 4n channel, with a yield of 45 nb. They were also able to detect a 10 s spontaneous fission activity also tentatively assigned to 256102. Further work in 1966 on the reaction examined the detection of 250Fm decay using chemical separation and a parent activity with a half-life of ~50 s was reported and correctly assigned to 254102. They also detected a 10 s spontaneous fission activity tentatively assigned to 256102. The reaction was used in 1969 to study some initial chemistry of nobelium at the FLNR. They determined eka-ytterbium properties, consistent with nobelium as the heavier homologue. In 1970, they were able to study the SF properties of 256No. In 2002, Patin et al. reported the synthesis of 256No from the 4n channel but were unable to detect 257No. The cross section values for the 4-6n channels have also been studied at the FLNR.
=== Pharmacodynamics === In rabbits, 2,3-dihydro-LSD had about 4% (1/25th) of the potency of LSD in inducing hyperthermia, while in mice, it was "equally toxic" (presumably referring to LD50Tooltip median lethal dose) as LSD.
=== Club records in UEFA competitions === As of 27 August 2026 Biggest win in UEFA competition: 9 November 2023, Freiburg 5–0 TSC, at Freiburg 30 November 2023, Freiburg 5–0 Olympiacos, at Freiburg Biggest defeat in UEFA competition: 14 March 2024, West Ham United 5–0 Freiburg, at London Club appearances in UEFA Europa League: 7 Player with most UEFA appearances: Matthias Ginter – 39 appearances Top scorer in UEFA club competitions: Vincenzo Grifo – 11 goals
Sources: en.wikipedia.org
In the nineteenth century numerous authors described both cretinism and myxedema, and their relationship to the thyroid. Charles Mayo coined the term hyperthyroidism in 1910. Hakaru Hashimoto documented a case of Hashimoto's thyroiditis in 1912, antibodies in this disease were demonstrated in 1956. Knowledge of the thyroid and its conditions developed throughout the late nineteenth and twentieth centuries, with many modern treatments and investigative modalities evolving throughout the mid twentieth century, including the use of radioactive iodine, thiouracil and fine needle aspiration.
Meinhard I 1253–1258, also Count of Gorizia since 1231 Meinhard II 1258–1295, also Count of Gorizia until 1271, Duke of Carinthia and Margrave of Carniola from 1286, jointly with: Albert V 1258–1271, brother, also Count of Gorizia until 1304 Albert VI, son, until 1292 Henry II 1295–1335, son of Meinhard II, also Duke of Carinthia, King of Bohemia 1306 and 1307–1310, jointly with his brothers Louis, until 1305 Otto, until 1310 Male line extinct, Countess Margaret, daughter of Henry II, married to:
== Precision fermentation == Precision fermentation is an approach to manufacturing specific functional products which intends to minimise the production of unwanted by-products through the application of synthetic biology, particularly by generating synthetic "cell factories" with engineered genomes and metabolic pathways optimised to produce the desired compounds as efficiently as possible with the available resources. Precision fermentation of genetically modified microorganisms may be used to manufacture proteins needed for cell culture media, providing for serum-free cell culture media in the manufacturing process of cultured meat. A 2021 publication showed that photovoltaic-driven microbial protein production could use 10 times less land for an equivalent amount of protein compared to soybean cultivation. Some Food Regulatory Agencies such as the FDA do not require the labeling of precision fermented foods as GMO since they are produced by, but do not contain the genetically engineered organisms. It is unclear how regulation will be handled in EU markets, with some startups such as Formo and Those Vegan Cowboys forming the Food Fermentation Europe (FFE) alliance together with other alt-protein startups to seek regulatory approval.
Sources: en.wikipedia.org
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.
The dry powder is commonly kept at minus twenty degrees Celsius, desiccated and away from light. Solutions are generally prepared fresh because they break down faster than the solid form.
Tandem mass spectrometry or enzymatic peptide mapping can establish residue order. A single intact mass value indicates composition and molecular weight but not always the precise arrangement of residues.
The peptide contains four residues in the order alanine, glutamate, aspartate and glycine, abbreviated AEDG. The chain is linear and held together by three peptide bonds. Its calculated mass for the uncharged free form is about 390.3 daltons.