This is a working overview of epitalon, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-06-06. Anything still debated is marked as such rather than presented as settled.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Linear tetrapeptide, also written AEDG |
| Molecular mass | About 390.35 g/mol | Value calculated from the sequence |
| Appearance | White to off-white powder | Lyophilised material forms a loose cake |
| Solubility | Freely soluble in water | Also dissolves in isotonic saline |
| Storage | -20 °C, desiccated | Aliquot solutions to avoid freeze–thaw cycling |
It is now generally held that with one exception (the amoeboid Paulinella chromatophora), chloroplasts arose from a single endosymbiotic event around two billion years ago and these chloroplasts all share a single ancestor. It has been proposed that the closest living relative of the ancestral engulfed cyanobacterium is Gloeomargarita lithophora. Separately, somewhere about 90–140 million years ago, this process happened again in the amoeboid Paulinella with a cyanobacterium in the genus Prochlorococcus. This independently evolved chloroplast is often called a chromatophore instead of a chloroplast. Chloroplasts are believed to have arisen after mitochondria, since all eukaryotes contain mitochondria, but not all have chloroplasts. This is called serial endosymbiosis—where an early eukaryote engulfed the mitochondrion ancestor, and then descendants of it then engulfed the chloroplast ancestor, creating a cell with both chloroplasts and mitochondria.
One interpretation of the data is that polypeptide monomers are often aligned in the multimer in such a way that mutant polypeptides defective at nearby sites in the genetic map tend to form a mixed multimer that functions poorly, whereas mutant polypeptides defective at distant sites tend to form a mixed multimer that functions more effectively. Direct interaction of two nascent proteins emerging from nearby ribosomes appears to be a general mechanism for homo-oligomer (multimer) formation. Hundreds of protein oligomers were identified that assemble in human cells by such an interaction. The most prevalent form of interaction is between the N-terminal regions of the interacting proteins. Dimer formation appears to be able to occur independently of dedicated assembly machines. The intermolecular forces likely responsible for self-recognition and multimer formation were discussed by Jehle.
The following outline is provided as an overview of and topical guide to diabetes mellitus (diabetes insipidus not included below): Diabetes mellitus – group of metabolic diseases in which a person has high blood sugar, either because the pancreas does not produce enough insulin, or because cells do not respond properly to the insulin that is produced, a condition called insulin resistance. The resultant high blood sugar produces the classical symptoms of polyuria (frequent urination), polydipsia (increased thirst) and polyphagia (increased hunger).
"He (Eannatum) defeated Zuzu, the king of Akshak, from the Antasurra of Ningirsu up to Akshak and destroyed him." "The king of Akshak ran back to his land." "He defeated Kish, Akshak, and Mari from the Antasurra of Ningirsu." "To Eannatum, the ruler of Lagash, Inanna gave the kingship of Kish in addition to ensi-ship of Lagash, because she loved him."
== Classification == Described primarily based on the type of biochemical group transferred, transferases can be divided into ten categories (based on the EC Number classification). These categories comprise over 450 different unique enzymes. In the EC numbering system, transferases have been given a classification of EC2. Hydrogen is not considered a functional group when it comes to transferase targets; instead, hydrogen transfer is included under oxidoreductases, due to electron transfer considerations.
Sources: en.wikipedia.org
A transdermal patch is a medicated adhesive patch that is placed on the skin to deliver a specific dose of medication through the skin and into the bloodstream. An advantage of a transdermal drug delivery route over other types of medication delivery (such as oral, topical, intravenous, or intramuscular) is that the patch provides a controlled release of the medication into the patient, usually through either a porous membrane covering a reservoir of medication or through body heat melting thin layers of medication embedded in the adhesive. The main disadvantage to transdermal delivery systems stems from the fact that the skin is a very effective barrier; as a result, only medications whose molecules are small enough to penetrate the skin can be delivered by this method. The first commercially available prescription patch was approved by the U.S. Food and Drug Administration in December 1979. These patches administered scopolamine for motion sickness. In order to overcome restriction from the skin, researchers have developed microneedle transdermal patches (MNPs), which consist of an array of microneedles, which allows a more versatile range of compounds or molecules to be passed through the skin without having to micronize the medication beforehand. MNPs offer the advantage of controlled release of medication and simple application without medical professional assistance required. With advanced MNPs technology, drug delivery can be specified for local usage, for example skin whitener MNPs that are applied to the face.
In North America: Alphora, Delmar and NAEJA, all Canada. AMRI, Aptuit, Cambridge Major, ChemBridge, Innocentive, Irix Pharmaceuticals and PharmEco, all USA. In Europe: Carbogen-Amcis, Switzerland; Chemcomm, Germany; ChemDiv, Russia; Clauson-Kaas, Denmark; Enamine Ltd, Ukraine; Girindus, Germany; Nerviano Medical Sciences, Italy; Recipharm, Sweden; Serichim, Italy; Solvias, Switzerland, Netherlands. In Asia: BioDuro, Medicilon, Pharmaron and WuXi AppTec, all China; Acoris, Aptuit Laurus, Biocon/Syngene, Chembiotek, Chempartner and ProCitius, all India; NARD Institute and Riken, both Japan. The business of CROs is usually done through a "pay for service" arrangement. Unlike manufacturing companies, invoicing of CROs is not based on unit product price, but on full-time equivalents (FTEs), or the cost of a scientist working one year on a given customer assignment. Companies offering both contract research and manufacturing services (CRAMS) combine the activities of CROs and CMOs. Their history is either a forward integration of a CRO, which adds industrial scale capabilities, or backwards integration of a CMO. As there are only limited synergies (>90% of the projects end at the sample preparation stage), it is questionable if one-stop shops really fulfil a need. Large fine chemical companies consider the preparation of samples more as marketing tool (and expense) rather than a profit contributor.
== Clinical significance == Anti-endomysial antibodies (EMA) are present in celiac disease. They do not cause any direct symptoms to muscles, but detection of EMA is useful in the diagnosis of the disease.
Obsessive–compulsive disorder (OCD), which happens to be its only US FDATooltip Food and Drug Administration-labeled indication. Other regulatory agencies (such as the TGA of Australia and the MHRA of the UK) have also approved clomipramine for this indication. A 2024 systematic review found that clomipramine is also effective in managing OCD in pediatric population. Major depressive disorder (MDD), a popular off-label use in the US. It is approved by the Australian TGA and the United Kingdom MHRA for this indication. In Japan it is also approved for depression. Some have suggested the possible superior efficacy of clomipramine compared to other antidepressants in the treatment of MDD, especially the more severe, although at the current time the evidence may be insufficient to more fully substantiate this claim. As-with other tricyclic antidepressants, the antidepressant response specifically may be augmented, including in treatment-resistant cases, with triiodothyronine, at a dosage of 50 mcg. In the case of clomipramine specifically, this may also be the case with OCD.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.
AEDG is the one-letter code for the four amino acids alanine, glutamate, aspartate and glycine in that order. The same molecule is written in three-letter form as Ala-Glu-Asp-Gly.
Identity is normally confirmed by mass spectrometry against the calculated mass of roughly 390.35 g/mol. Purity is then estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection.
It is a four-amino-acid peptide built from alanine, glutamate, aspartate and glycine in that order. Its formula is C14H22N4O9, and it is made by chemical synthesis rather than extracted from tissue. The synthetic peptide is a single defined molecule, unlike the pineal extracts it is often compared with.